A LONGSHOT Beam Antenna Or CB Directional Antenna
A cb directional antenna or cb beam antenna is an antenna which radiates or receives greater power in specific directions allowing increased performance and reduced interference from unwanted sources. Directional antennas provide increased performance over dipole antennas—or omnidirectional antennas in general—when greater concentration of radiation in a certain direction is desired.
A high-gain wire cb beam antenna (HGA) is a directional antenna with a focused, narrow radiowave beam width, permitting more precise targeting of the radio signals. Most commonly referred to during space missions, these antennas are also in use all over Earth, most successfully in flat, open areas where there are no mountains to disrupt radiowaves. By contrast, a low-gain antenna (LGA) is an omnidirectional antenna with a broad radiowave beam width, that allows the signal to propagate reasonably well even in mountainous regions and is thus more reliable regardless of terrain. Low-gain CB Beam Antenna are often used in spacecraft as a backup to the high-gain antenna, which transmits a much narrower beam and is therefore susceptible to loss of signal.
All practical wire cb antennas are at least somewhat directional, although usually only the direction in the plane parallel to the earth is considered, and a practical wire beam antenna can easily be omnidirectional in one plane. The most common types are the Yagi antenna, the log-periodic antenna, and the corner reflector antenna, which are frequently combined and commercially sold as residential wire TV antennas. Cellular repeaters often make use of external directional wire antennas to give a far greater signal than can be obtained on a standard cell phone. Satellite television receivers usually use parabolic antennas. For long and medium wavelength frequencies, tower arrays are used in most cases as directional antennas.
Principle Of Longshot Beam Operation
When transmitting, a high-gain wire CB beam antenna allows more of the transmitted power to be sent in the direction of the receiver, increasing the received signal strength. When receiving, a high gain wire CB beam antenna captures more of the signal, again increasing signal strength. Due to reciprocity, these two effects are equal—an antenna that makes a transmitted signal 100 times stronger (compared to an isotropic radiator) will also capture 100 times as much energy as the isotropic wire antenna when used as a receiving CB Beam Antenna. As a consequence of their directivity, directional CB antennas also send less (and receive less) signal from directions other than the main beam. This property may be used to reduce interference.
There are many ways to make a high-gain wire antenna for CB; the most common are parabolic antennas, helical antennas, yagi antennas, and phased arrays of smaller antennas of any kind. Horn antennas can also be constructed with high gain, but are less commonly seen. Still other configurations are possible—the Arecibo Observatory used a combination of a line feed with an enormous spherical reflector (as opposed to a more usual parabolic reflector), to achieve extremely high gains at specific frequencies.
CB Beam Antenna gain
CB Beam Antenna gain is often quoted with respect to a hypothetical wire antenna that radiates equally in all directions, an isotropic radiator. This gain, when measured in decibels, is called dBi. Conservation of energy dictates that high gain antennas must have narrow beams. For example, if a high gain wire antenna makes a 1 watt transmitter look like a 100 watt transmitter, then the beam can cover at most 1⁄100 of the sky (otherwise the total amount of energy radiated in all directions would sum to more than the transmitter power, which is not possible). In turn this implies that high-gain antennas must be physically large, since according to the diffraction limit, the narrower the beam desired, the larger the antenna must be (measured in wavelengths).
CB Beam Antenna gain can also be measured in dBd, which is gain in Decibels compared to the maximum intensity direction of a half wave dipole. In the case of Yagi type aerials this more or less equates to the gain one would expect from the aerial under test minus all its directors and reflector. It is important not to confuse dBi and dBd; the two differ by 2.15 dB, with the dBi figure being higher, since a dipole has 2.15 db of gain with respect to an isotropic wire antenna.
Longshot beam antenna gain is also dependent on the number of elements and the tuning of those elements. Wire antennas can be tuned to be resonant over a wider spread of frequencies but, all other things being equal, this will mean the gain of the aerial is lower than one tuned for a single frequency or a group of frequencies. For example, in the case of wideband TV antennas the fall off in gain is particularly large at the bottom of the TV transmitting band. In the UK this bottom third of the TV band is known as group A; see gain graph comparing grouped aerials to a wideband aerial of the same size/model.
Other factors may also affect gain such as aperture (the area the CB Beam Antenna collects signal from, almost entirely related to the size of the wire antenna but for small antennas can be increased by adding a ferrite rod), and efficiency (again, affected by size, but also resistivity of the materials used and impedance matching). These factors are easy to improve without adjusting other features of the antennas or coincidentally improved by the same factors that increase directivity, and so are typically not emphasized.
CB Beam Antenna Applications
High gain antennas are typically the largest component of deep space probes, and the highest gain radio antennas are physically enormous structures, such as the Arecibo Observatory. The Deep Space Network uses 35 m dishes at about 1 cm wavelengths. This combination gives the antenna gain of about 100,000,000 (or 80 dB, as normally measured), making the transmitter appear about 100 million times stronger, and a receiver about 100 million times more sensitive, provided the target is within the wire beam. This beam can cover at most one hundred millionth (10−8) of the sky, so very accurate pointing is required.
Use of high gain and Millimeter-wave communication in WPAN gaining increases the probability of concurrent scheduling of non‐interfering transmissions in a localized area, which results in an immense increase in network throughput. However, the optimum scheduling of concurrent transmission is an NP-Hard problem.
A Narrow Beam Width Antenna Or Fan-beam Antenna
A fan-beam antenna is a directional antenna producing a main wire beam having a narrow beamwidth in one dimension and a wider beamwidth in the other dimension. This pattern will be achieved by a truncated paraboloid reflector or a circular paraboloid reflector. Since the reflector is narrow in the vertical plane and wide in the horizontal, it produces a wire beam that is wide in the vertical plane and narrow in the horizontal. (The larger the wire antenna dimension, the narrower the beam.)
Fan beam antennas are used in radar sets. Primary radar in airport have often fan-beam with the section of antenna oriented horizontally to give a narrow beam in azimuth. They must then be complemented with a height finders have the wire beam oriented horizontally because they cannot locate the altitude. Those have their reflector rotated 90 degrees and produce a CB Beam Antenna that is wide in the horizontal plane but narrow in the vertical.